BIOS - B4U DIGITAL READ-OUT
B4U_V190.BIO

ITA - GB - F - D
(21/12/2005)   229 KB - Milling/Turning Version 1.9

BIOS UPDATING SOFTWARE
BIOS.EXE

ATTENTION!
The BIOS updating is a very delicate operation that requires the presence of skilled operators as a matter of PC procedures. If wrongly or not completely   carried out, the required operations could damage the preset. In the case these operations   have negative result, please repeat this procedure starting   from the beginning,   by a manual selection of the communication port; then set the heading   “ONLY UPDATING”.
The BIOS updating may require to delete the digital read-out memory content.
Updating your preset software (BIOS) means   to have always available the most tested and reliable version.
In order to run the updating, it is necessary to link the digital read-out to the PC by using a “Laplink “ standard serial cable, bought or built following the instructions that will appear on the screen during the updating programme execution.
First of all, please check which software version is installed on your digital read-out.
In the BIOS list, please check the availability of the most recent version; then download the updating the proper file, suitable for your preset, just clicking on its relative linking.
Please install and run the BIOS updating software, then follow the guided procedure.